Washing machine not spinning: common causes and when to call a repair service

Water standing in the drum and the laundry soaking wet? What you can check yourself in ten minutes, what is a job for a technician, and what to ask before they come.

Updated 24 Oct 2026 · 2 min read

Draft. This text is waiting for review by an expert in the field before it is published.

A washing machine with its door open and a basket of laundry in front of it

The machine finishes its programme, but the laundry is soaking or there is water standing in the drum. It’s one of the most common faults, and you can often fix it without a technician. First, unplug the machine and turn off the water supply.

If there is hot water in the drum, wait for it to cool down. Don’t force the door: the lock releases only once the machine has drained or after a few minutes without power.

1. A blocked pump filter

The most common cause. Behind a small flap at the bottom of the front of the machine is a filter that catches coins, buttons, hair and pet fur. When it clogs, the water can’t get out, and a machine that can’t drain won’t spin.

Put a shallow tray and towels in front of the machine, slowly unscrew the filter and let the water run out. Rinse the filter under the tap and screw it back in firmly. If the machine then works normally, the fault is fixed.

2. Too much or too little laundry

Before spinning, the machine checks that the drum is evenly loaded. If all the laundry is on one side, for example a single wet duvet cover or two towels, the machine skips the fast spin so it doesn’t shake. Spread the laundry out or add a few more items and run just the spin programme.

3. The drain hose

Check that the hose behind the machine isn’t kinked, squashed against the wall or blocked where it goes into the drain. If the sink drains slowly, the machine has the same problem.

4. When it’s a job for a repair service

If the filter is clean, the laundry is spread out and the hose is clear, but the machine still won’t spin, the fault is usually in one of these parts:

  • Drain pump: it hums but doesn’t pump the water out, or it is completely silent;
  • Motor or its brushes: the drum turns slowly or not at all;
  • Belt: on older machines the drum doesn’t turn, but you can hear the motor;
  • Electronics or water level sensor: the machine shows an error or stops in the middle of a programme.

Don’t replace these parts yourself unless you have experience: this is electricity and water together.

What to tell the technician

A good request saves a visit. Write down:

  • the brand and, if you know it, the model (it’s on the label inside the door or on the back);
  • how old the machine is;
  • what exactly it does: hums, stops, shows an error (copy the code from the display);
  • what you’ve already checked, for example that the filter is clean.

The technician can then tell you an indicative price for the diagnosis right away, and whether they are likely to bring the part with them.